Your Ad Here

Thursday, September 30, 2010

How to make Acid

I decided to share with you folks out there detailed instructions on how to make Acid, feel free to post this anywhere else you would like and please do not try this in an enclosed area, let it air out or you'll probably feint and die.

Materials:

1. Ergotamine tartrate

2. Hydrazine hydrate

3. Hydrazide

4. Hydrochloric Acid

5. Sodium Nitrite

6. Sodium Bicarbonate

7. Diethylamine

8. Ether

9. Flasks

10. Filter paper

11. Heating mantle

12. 2 liter three-necked round bottom flask

Time: Approximately 36 hours.

Process:

STEP 1: In a 2 liter three-necked round bottom flask
add to 2 grams of ergotamine tartrate about 1/2 gram
of hydrazine hydrate. Exercise caution when adding
the hydrazine hydrate because it is very poisonous,
particularly to the eyes.

STEP 2: Place a condensing column on one neck of the
flask. Place a stirring device in the center neck and
place a separatory funnel in the thick neck. (Note:
hydrazide hydrate may be added through a separatory
funnel although it is not necessary.)

STEP 3: Place the flask on a heating mantle and simmer
the solution for 2-3 hours while stirring occasionally.

STEP 4: Remove condensing column from flask and continue
to cook for 10-15 minutes or until the original solution
is reduced by half.

STEP 5: After solution has cooled, pour the solution
through filter paper and collect the crystals that
formed. Wash the crystals in a small amount of
absolute alcohol.



STEP 6: Dissolve the crystals in about 30cc of diluted
hydrochloric acid. (Note: diluted hydrochloric acid is
mixed at a rate of 1 part acid to 10 or 15 parts water.)

STEP 7: To the hydrochloric acid solution add about
15cc of a solution of sodium nitrite diluted in water.
(Note: one part sodium nitrite to 10 or 15 parts
water.) Let this solution stand for about 30 minutes.

STEP 8: To this solution add about one teaspoonful of
sodium bicarbonate (baking soda) to make the solution
basic.

STEP 9: Place this solution in a separatory funnel and
add to it an equal quantity of ether. Shake this
solution gently for about 5 minutes.

STEP 10: Separate the ether solution from the
separatory funnel and keep the ether solution. The
remainder may be discarded.

STEP 11: Cool the ether solution to 0 degrees Celsius
and to the solution add a solution of about .5 gram
of diethylamine mixed with ether.

STEP 12: Maintain the solution at 0 degrees Celsius for
24 hours, stirring it occasionally (perhaps 4 hour
intervals.)

STEP 13: Remove the solution from the ice bath and
allow it to stand at room temperature for about 2
hours, or until it evaporates. The remaining crystals
will be crude LSD.

Obviously you should not attempt this method without at least
some first-year state level Chemistry.

Breathing in the fumes can send you tripping, so be careful.

13 comments: